System information

Program 21 : Outgoing Call Setup
21-01 : System Options for Outgoing Calls
UX5000 Software Program Manual Programming ◆ 359
Program 21 : Outgoing Call Setup
21-01 : System Options for Outgoing Calls
Description
Use Program 21-01 : System Options for Outgoing Calls to set the UX5000 options for Outgo-
ing Call Service.
Input Data
Level:
Feature Availability
IN • Available.
Item
No.
Item Input Data Default Related Program
01 Seizure Trunk Line Mode
Determine if trunks are seized based on prior-
ity (set in Program 14-05/14-06) or if by next
available (longest free).
0 = Priority route
1 = Circular route
0 14-05
14-06
02 Intercom Interdigit Time
When placing Intercom calls, extension users
must dial each digit within this interval.
0-64800 Seconds 10 20-31-04
03 Trunk Interdigit Time (External)
The UX5000 waits for this timer to expire
before placing the call in a talk state (Call
Timer starts after timer expires, Voice Over
and Barge-In are not allowed until after timer
expires). If set to “0”, Voice Over and Barge
In will not work for external calls.
This timer affects CO and PRI outdialing.
0 = Disabled
1-64800 Seconds
5 14-02-08
20-31-05
04 Dial Tone Detection Time
If dial tone detection is enabled, the UX5000
will wait this interval for the Telco to return
dial tone. When the interval expires, the
UX5000 assumes dial tone is not present. To
disable this timer (and have the UX5000 wait
continuously), enter 0. This timer is also used
to determine the time allowed between
Account Code digit entry.
0-64800 Seconds 5 14-02-05
35-05-01
05 Disconnect Time
The UX5000 waits for this timer to expire
before disconnecting a call when dial tone is
not detected.
0-64800 Seconds 3
06 Dial Pause at First Digit
Before outdialing the first digit, the UX5000
waits this interval before outdialing a user’s
first manually-dialed digit. Additional digits
outdial without delay.
0-64800 Seconds 1 14-02-06