System information

Program 20 : System Option Setup
20-03 : System Options for Single Line Terminals
UX5000 Software Program Manual Programming ◆ 297
20-03 : System Options for Single Line Terminals
Description
Use Program 20-03 : System Options for Single Line Terminals to set up various options for
Single Line Terminals.
Input Data
Level:
Feature Availability
IN • Available.
Item
No.
Item Input Data Default
Related
Program
01 SLT Call Waiting Answer Mode
For a busy single line (500/2500 type) terminal, set the
mode used to answer a camped-on trunk call.
For ESL sets, enabling this option (1) allows the user to
dial Service Code 154 for Voice Mail Conversation
Record.
0 = Hook Flash
1 = Hook Flash + Service
code (894)
0 11-12-47
02 Ignore Received DP Dial on DTMF SLT Port
Use this option to define whether the UX5000 should
receive dial pulse and DTMF signals (0) or ignore dial
pulse and only accept DTMF signals (1).
0 = Do Not Ignore
1 = Ignore
0 15-03-01
03 SLT DTMF Dial to Trunk Lines
• Type 0 : The UX5000 keeps the digits dialed by the
SLT on a trunk in a buffer. After all the digits have
been received, the UX5000 sends all the digits to the
trunk. If the time space between digits is longer than
the timer in Item 4, the UX5000 considers all digits
received.
• Type 1 : The UX5000 passes the received digits from
the SLT to the trunk immediately. If the SLT has a
Last Number Dial key without a pause, this key may
not be able to use the Last Number Dial key with the
Type 1 setting.
When using a 3rd-party external paging device, set this
option to “1”. In addition, set Program 20-03-04 to “1”.
These programs must be set in order for IP DECT users
to be able to break dial tone on an analog trunk that is
used for paging.
If an UX5000 is used as a PBX/Centrex system with
Centrex Call Forwarding feature:
When a UX5000 is connected to a PBX system and it
uses a trunk defined as "Behind PBX" in Program
14-04-01 to place the Call Forward, it is strongly recom-
mended that the PBX/Centrex system have immediate
dial enabled (set to 1) and not store and forward.
0 = Receive all dialed
data, before sending.
1 = Direct through out
0 20-03-04