System information

Program 15 : Extension, Basic Setup
15-03 : Single Line Terminal Basic Data Setup
238 ◆ Programming UX5000 Software Program Manual
07 On Hook When Holding (SLT)
After placing a call on hold, determine if the SLT
should be able to place the handset back on hook.
0 = Disable
1 = Enable
1
08 Answer on hook when holding (SLT) 0 = Disable
1 = Enable
1 11-12-46
09 Caller ID Function - For External Module
Enable (1) or disable (0) the Caller ID FSK signal for
an external Caller ID module or a 3rd party vendor
phone with Caller ID display. With the Caller ID
Sender Queueing feature, set this option to “1” for
the extension.
Important: If voice mail is used, this setting must be
disabled or the UX5000 integration codes for discon-
nect will be incorrect.
Note: With some earlier software, if a 2500 set (no
Caller ID) is installed, this must be set to “0” or else
incoming callers will not have a talkpath.
0 = Disable
1 = Enable
0
10 Caller ID Name
Determine if an extension user’s terminal should dis-
play the Caller ID name.
0 = Disable
1 = Enable
1 14-02-10
20-09-02
11 Caller ID Type
- Not Used in U.S. -
This option allows you to select either FSK or
DTMF as the Caller ID type to be received by a sin-
gle line terminal.
0 = FSK
1 = DTMF
0 14-02-16
12 - Not Available -
13 MW Signal Type
For analog single line terminals which provide a dis-
play, when a user leaves a Message Waiting for a
SLT which has a display, this option is used to deter-
mine whether the SLT user will see a MW LED indi-
cation or if the Caller ID will be used to display the
call.
0 = Lamp
Indication
(-112 VDC +-3
VDC)
1 = Caller ID
Indication
(FSK)
0
14 Forwarded Caller ID Display Mode
When transferring a CO call to an analog SLT, set
this option to “1” if Caller ID from the CO should be
displayed on the transferred terminal’s display.
Selecting “0” will display the transferring extension
information.
0 = Calling
1 = Forward
0
15 Disconnect Without Dial After Hooking Hold
Not Used in U.S. - Do Not Change Default Entry
-0
16 Special DTMF Protocol Send
For each analog port, enable (1) or disable (0) the
ability to send the extension number of the terminal
that forwarded to it when not assigned a voice mail
port. This setting is ignored if a voice mail depart-
ment group number is defined in Program 45-01-01.
0=No
1=Yes
0 45-01-16