System information

Program 15 : Extension, Basic Setup
15-03 : Single Line Terminal Basic Data Setup
UX5000 Software Program Manual Programming ◆ 237
15-03 : Single Line Terminal Basic Data Setup
Description
Use Program 15-03 : Single Line Terminal Basic Data Setup to set up various single line termi-
nal options.
Input Data
Level:
Feature Availability
IN • Available.
Extension Number Max. 8 digits
Item
No.
Item Input Data Default
Related
Program
01 SLT Signaling Type
Use this option to tell the UX5000 the type of dialing
the connected terminal uses.
For each UX5000 Mail extension, this option must
be set to “0”.
In order for the IP DECT terminals to function cor-
rectly, this must be set to ’0’ (dial pulse). If this
option is set for DTMF, after an outside call is
placed, the UX5000 will not dial any additional dig-
its.
This program change is automatically performed
when the IP DECT terminal is registered.
0 = DP
1 = DTMF
1
02 Loop Current
- Not Used in U.S. -
0 = 20mA
1 = 35mA
0
03 Terminal Type
Enter 1 for this option to allow a single line port to
receive DTMF tones after the initial call setup. Enter
0 to have the port ignore DTMF tones after the initial
call setup. For Voice Mail, always enter 1 (e.g.,
receive DTMF tones).
0 = Normal
1 = Special
1
04 Flashing
Enables/disables Flash for single line (500/2500
type) terminals
0 = Disable
1 = Enable
1
05 External Reverse
Not Used in U.S. - Do Not Change Default Entry as
DTMF issues may arise with voice mail.
0 = Disable
1 = Enable
0
06 Extension Reverse
Not Used in U.S. - Do Not Change Default Entry as
DTMF issues may arise with voice mail.
0 = Disable
1 = Enable
0