System information

Program 14 : Trunk, Basic Setup
14-02 : Analog Trunk Data Setup
204 Programming UX5000 Software Program Manual
14-02 : Analog Trunk Data Setup
Description
Use Program 14-02 : Analog Trunk Data Setup to set the basic options for each analog trunk
port. Refer to the chart below for a description of each option, its range and default setting.
Input Data
Level:
Feature Availability
IN Available.
Trunk Port Number 1-200
Item
No.
Item Input Data Default
Related
Program
01 Signaling Type (DP/DTMF)
This option sets the signaling type for the trunk.
0 = Dial Pulse (10 PPS)
1 = Dial Pulse (20 PPS)
2 = DTMF
2
02 Ring Detect Type
This option sets Extended Ring Detect or Immediate
Ring Detect for the trunk. For T1 loop/ground start
trunks, this option must be set to ‘1’ in order for the
trunks to ring and lamp correctly.
0 = Normal/delayed
1 = Immediate ringing
0
03 Flash Types
This option to select the ash type (open loop ash
or ground). Always set this option for open loop
ash.
0 = Open Loop Flash
1 = Ground
0
04 Flash For Timed Flash or Disconnect
This option lets you use Flash for Timed Flash (Pro-
gram 81-01-14) or Disconnect (Program 81-01-15).
(A user implements Flash by pressing the FLASH
key while on a trunk call.)
0 = Timed ash/Hooking
1 = Disconnect
0 81-01-14
81-01-15
05 Dial Tone Detection for Directly Accessed Trunks
Use this option to enable/disable dial tone detection
for directly accessed trunks. If disabled, the
UX5000 outdials on the trunks without monitoring
for dial tone.
If there are no DSP resources, this program will be
ignored.
0 = Dial Tone Detection
not used
1 = Dial Tone Detection
used
0 21-01-04
06 Pause at 1st Digit After Line Seize in Manual
Dial Mode
Use this option to enable/disable a pause before the
UX5000 outdials a manually dialed call on the
trunk. If enabled, the UX5000 will wait before out-
dialing the dialed digits. If disabled, the UX5000
outdials the digits as the user dials them. Set the
pause interval timer in Program 21-01-06.
0 = No Pause
1 = Pause
1 21-01-06