System information

Introduction to Programming
Before You Start Programming
2 ◆ Programming UX5000 Software Program Manual
How to Enter the Programming Mode
To enter the programming mode:
1. Go to any working display terminal.
In a newly installed UX5000, use extension 301 (port 1).
Programming access may be restricted based on the type of program entry used and if
other users are connected to the UX5000 for programming purposes.
PC Pro: Only one user allowed access to the UX5000 programming at a time.
WebPro: Up to 4 WebPro or TelPro users can be connected at the same time.
TelPro: Up to 4 TelPro or WebPro users can be connected at the same time.
2. Do not lift the handset.
3. Press CALL1.
4. # * # *
5. Dial the UX5000 password + HOLD.
Refer to the following table for the default UX5000 passwords. To change the pass-
words, use Program 90-02.
Note: When changes are made to the following programs, the UX5000 must be restarted.
Password
Password User Name Level Programs at this Level
12345678 UX5000 2 (IN) All programs in this section not listed below for SA and SB
0000 ADMIN1 3 (SA) 10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16, 10-17, 10-18, 10-22,
10-23, 10-24, 10-25, 10-27, 10-28, 10-29, 10-31, 12-02, 12-03, 12-04,
12-08, 13-04, 13-05, 15-01, 15-07, 15-09, 15-10, 15-11, 15-14, 20-16,
20-34, 21-07, 21-14, 22-04, 22-11, 22-17, 25-08, 30-03, 30-04, 32-02,
40-02, 41-02, 41-03, 41-04, 41-05, 41-06, 41-07, 41-08, 41-09, 41-10,
41-11, 41-12, 41-13, 41-14, 41-15, 41-16, 41-17, 41-18, 41-19, 41-20,
45-02, 45-03, 84-22, 90-03, 90-04, 90-06, 90-07, 90-19
9999 ADMIN2 4 (SB) 13-04, 13-05, 15-14
10-12-01 10-16-01 80-02-03 84-04 84-06-07
10-12-02 10-16-02 80-02-04 84-05-01 84-06-08
10-12-03 10-16-03 80-03 84-05-02 84-06-09
10-12-04 10-16-04 80-04 84-06-01 84-06-10
10-13-01 20-01-03 84-03-01 84-06-02 84-06-11
10-13-02 47-01-01 84-03-02 84-06-03 84-09
10-13-03 80-01 84-03-06 84-06-04 84-10
10-14 80-02-01 84-03-07 84-06-05
10-15 80-02-02 84-03-08 84-06-06