System information

Introduction to Programming
Before You Start Programming
UX5000 Software Program Manual Programming ◆ 1
Introduction to Programming
Before You Start Programming
Before Reading This Section
This manual provides you with detailed information about the UX5000 programs. By changing a
program, you change the way the feature associated with that program works. In this manual, you
find out about each program, the features that the program affects and how to enter the program
data into UX5000 memory.
When you want to customize a feature, find it in Software Features Manual and learn about it. The
Software Features Manual will tell you what programs you have to change to get the operation you
want. Then, look the program up in this manual if you have any questions about how to enter the
data.
How to Use This Section
This manual lists each program in numerical order. For example, Program 10-01 is at the beginning
of the manual and Program 92-01 is at the end. The information on each program is subdivided into
the following headings:
Description describes what the program options control. The Default Settings for each program are
also included. When you first install the UX5000, it uses the Default Setting for all programs.
Along with the Description are the Conditions which describe any limits or special considerations
that may apply to the program.
The reverse type (white on black) just beneath the Description heading is the program’s access
level. You can only use the program if your access level meets or exceeds the level the program
requires. Refer to How to Enter the Programming Mode (page 2) for a list of the UX5000’s
access levels and passwords.
Feature Cross Reference provides you with a table of all the features affected by the program.
You’ll want to keep the referenced features in mind when you change a program. Customizing a
feature may have an effect on another feature that you didn’t intend.
Terminal Programming Instructions shows you how to enter the program’s data into UX5000
memory. For example:
1. Enter the programming mode.
2. 15-07-01
tells you to enter the programming mode, dial 150701 from the terminal dial pad. After you do,
you’ll see the message “15-07-01 TEL301” on the first line of the terminal display. This indicates
the program number (15-07), item number (01), and that the options are being set for extension
301. The second row of the display “KY01 = *01” indicates that Key 01 is being programmed with
the entry of *01. The third row allows you to move the cursor to the left or right, depending on
which arrow is pressed. To learn how to enter the programming mode, see How to Enter the Pro-
gramming Mode
below.
Do not start customizing your UX5000 without first reading the
UX5000 Software Features Manual, P/N 0913201.
15-07-01 TEL301
KY01 = *01
← →