System information

Program 11 : System Numbering
11-01 : System Numbering
120 ◆ Programming UX5000 Software Program Manual
Step 2: Specify the length of the code you want to change
After you specify a single or two digit code, you must tell the UX5000 how many digits com-
prise the code. This is the Number of Digits Required column in the System Numbering
(page 122) table. In the default program, all codes from 100-999 are three digits long. Codes
beginning with 0 are one digit long. Codes beginning with * are 3 digits long and codes begin-
ning with # are 4 digits long.
● If you are programming two digit codes in the PC Program, make sure the nX entry for
Number of Digits Required is the maximum allowed by any of the two digit codes in the
range. This is why the default Number of Digits Required entry for #X is four digits
long. Even though #1-#9, #0 and ## entries require only two digits, #* requires four. If
you inadvertently change #* to 2, you will no longer be able to enter #*#* to enter the
programming mode.
Step 3: Assign a function to the code selected
After entering a code and specifying its length, you must assign its function. This is the Dial
Type column in the System Numbering (page 122) table. The choices are:
Dial Types Dial Type Description Related Program
0 - Not Used -
1 Service Code 11-10 : Service Code Setup (for System Administrator)
11-11 : Service Code Setup (for Registration)
11-12 : Service Code Setup (for Service Access)
11-13 : Service Code Setup (for ACD)
11-14 : Service Code Setup (for Hotel/Motel)
11-15 : Service Code Setup (Special access)
2 Extension Number 11-02 : Extension Numbers
11-04 : Virtual Extension Numbers
11-06 : 2PGDAD (ACI) Extension Numbers
11-07 : Department Calling Group Numbers
11-08 : 2PGDAD (ACI) Group Pilot Numbers
3 Trunk Access Code 11-09 : Trunk Access Code
4 Special Trunk Access 11-09 : Trunk Access Code
5 Operator Access 20-17 : Operator’s Extension
6 ARS/F-Route Access 44-xx
8 CygniLink 10-03 : Blade Setup
10-12 : CPU (FEC 1) Network Setup
10-20 : LAN Setup for External Equipment
10-27 : IP System ID
10-44 : CPU (FEC 2) Network Setup