System information

Program 10 : System Configuration Setup
10-42 : Virtual Loop Back Port Setting
UX5000 Software Program Manual Programming ◆ 97
10-42 : Virtual Loop Back Por t Setting
Description
Use Program 10-42 : Virtual Loop Back Port Setting to define the parameters of the Virtual
Loop Back port as used with ISDN.
Input Data
Conditions
None
Level:
Feature Availability
IN • Available.
Item
No.
Item Input Data Default
Related
Program
01 Number of Loop Back Ports
Define the number of Virtual Loop Back ports.
0-23
(0=No setting)
0
02 Logical Trunk Port Number
This item is view-only and displays the begin-
ning trunk port used for Virtual Loop Back.
0-168 0
03 Logical Extension Port Number
This item is view-only and displays the begin-
ning extension port used for Virtual Loop Back.
0-480 0
04 Layer 3 Timer Type
This is the same as Program 10-03-04 (for PRI).
Each timer value of Layer3 is set up for each type
in Program 81-06 (T-Bus) and Program 82-06
(S-Bus).
1-5 1 Same as
Program
10-03-04
(for PRI)
05 Calling Party Number
This is the same as Program 10-03-05 (for PRI).
Based on this setting, the UX5000 will include a
“Presentation Allowed” (1) or “Presentation
Restricted” (0) in the Setup message to allow or
deny the Calling Party Number. Program 15-01-04
must also be set to a ‘1’ if this option is enabled.
0 = Disable
1 = Enable
1 Same as
Program
10-03-05
(for PRI)
06 S-Bus DID Digits
This is the same as Program 10-03-07 (for PRI).
0-4 0 Same as
Program
10-03-07
(for PRI)
07 Call Busy Mode for S-Bus 0 = Alerting Message
1 = Disconnect Message
0 Same as
Program
10-03-15
(for PRI)