Specifications

CAD11
Bridging two amplifiers
Remote bass
level control.
To Remote on
head unit
GROUND
Battery
Fuse
Distribu-
tion block
Power Cap
You can connect t two CAD11 in
bridge mode.
One of the amplifiers is ”Master”
that controls the signal to the
second amplifier that should be
used in ”Slave” position. The sig-
nal is fed through the Data link
connector. Connect the
amplifiers as in the drawings
below.
Master slave selector & Data link
connection
Data
Link
Speaker
impedance:
4 ohm/2 ohm
From low level
output of head unit
Bridged
mode
Master
Slave
Bridged
mode
Master
Slave
Bridged
mode
Master
Slave
Bridged switch:
Slave position
Bridged switch:
Master position
Connection of DC-input and Remote sub level control
7
Connecting two CAD11 in bridge mode will dou-
ble the output power. Minimum speaker load is
then 2 ohms. The output power with a 4 ohm
load is 1500 Watts, and with 2 ohm load 2000
Watts. The RCA signal must be connected only
to the amplifer set to run as ”Master”.
The filters as well as the level control is only
working on the ”Master” amplifier.
Bridging two amplifiers can be done only
between amplifiers of the same model
Modular 4-pole cable to connect
between Data Link sockets