User Manual

Installation
Pre installation
Disconnect Battery
Before you start the process
of replacing speakers,
disconnect and secure the
negative terminal from your
battery/power source. This
will prevent the risk of
damaging yourself or the
products.
Place the disconnected terminal in a secure and
isolated location away from any possible
connection belonging to the battery/power source
system.
Some sound systems may vary in size of the door
speaker. Make sure that your vehicle has the same
size as this kit, before you start the assembly
This is a generic mounting instruction. The
approach is similar to all of the described car
models. Some screws and clips may be placed
differently and depending, if the tweeter is placed
in the A-pillar or side mirror, the course of action
may vary.
General info
Included products:
2pcs Woofer
2pcs Tweeter
2pcs Crossover
Included in box:
2pcs Woofer
2pcs Tweeter
2pcs Crossover
2pcs Included bottom adapter
2pcs Flat-bottom adapter
2pcs Woofer connection line (for loose ends)
2pcs Tweeter connection line (for loose ends)
4pcs Adhesive foam with NC function
8pcs Terminal crimp connectors
4pcs Foam for wrapping
4pcs Screw
2pcs Adhesive for tweeter inclined adapter
8pcs Blind rivet
1pcs Rivet Tool
1pcs Manual
Unscrew the screws and store them in a safe
position, to re-use when re-mounting the door
panel.
Dismount the speaker grill by using the PRY tool.
Start the dismount
Tools that are needed
• Phillips screwdriver
• Screwdriver for slot screw. (ab 5mm)
• PRY tools (to avoid marks on the panels)
3