Specifications

Speaker wiring CA 20 & CA21
Two fullrange speakers to CA20 or CA21
HPF
Off On
50Hz 220Hz
15Hz 500Hz
LPF
Off On
80Hz 200Hz
50Hz 500Hz
CA20 CA21
LPF
Off 24 dB
80Hz 200Hz
50Hz 500Hz
12dB
With the HPF-filter in OFF position the amplifier
allows the speakers to play fullrange. If you for
some reason want to limit the low bass
reproduction switch on the HPF-filter. The typical
setting is then around 25 – 40 Hz.
The LPF-filter should be OFF.
One subwoofer connected in bridge mode to
CA20 or CA21
The HPF filter is here used as subsonic filter to take
away the very deepest frequencies. The typical set-
ting is around 25 – 40 Hz.
CA20 CA21
The LPF will allow low frequencies only and blocks
higher frequencies. A typical setting is 70 – 100
Hz.
In the CA21 amplifier you can select between two
different slopes, 12 dB/ octave or 24 dB/ octave.
Choose the slope and the setting that sounds best
in your car.
LPF
Off On
80Hz 200Hz
50Hz 500Hz
LPF
Off 24 dB
80Hz 200Hz
50Hz
500Hz
12dB
HPF
Off On
50Hz 220Hz
15Hz 500Hz
Filter settings
NOTE!
4 ohm minimum load when using bridge mode
connection. Lower impedances may damage the
amplifier. In bridge mode the amplifier sees a 4
ohm load as 2 ohm.
Filter settings
8
CA20, 21
REM