Specifications

All models include

# RCA inputs CA20

# High Level input 2 x 50 Watt RMS / 2 x 100 Watt peak

# Continuos variable low pass and/or high pass 1x 170 Watt RMS / 1 x 300 Watt peak

crossover CA21

# Bass boost feature (not on CA50) 2 x 100 Watt RMS / 2 x 200 Watt peak

# Remote turn on / off 1 x 350 Watt RMS / 1 x 600 Watt peak

# Automatic remote turn on/ off on high level CA40

input without connecting any remote wire 4 x 50 Watt RMS / 4 x 100 Watt peak

# Electronic protection circuitry against 2 x 170 Watt RMS / 2 x 300 Watt peak

short-circuit, DC offset and thermal overload. CA50

Bridgeable design to direct full power to 4 x 50 Watt RMS / 4 x 100 Watt peak

one or two subwoofers etc. 2 x 150 Watt RMS / 2 x 200 Watt peak

1 x 150 Watt RMS on Sub channel

All above output power ratings in

four ohms stereo,respectively bridged

at 13,8 Volt ,max 0,1 resp. 0,2 % THD

Installation

Before you begin installation

Before you begin you need to read the manual, to have

some tools, cables and other material available. There

is one such list of material on the following page.

Amplifier location

Important

Allow air circulation around the amplifier.

Disconnect Battery

Before starting the instal-

lation, always disconnect

the negative terminal of

the battery.

The DLS Classic series of amplifiers have a

compact design that allows great flexibility in

mounting. You can mount it under a seat or in the

trunk.

When you select a location, do remember that the

amplifier generates a lot of heat.

Choose a location where air can circulate freely

around the amplifier. Do not cover the amplifier

with carpets or hide behind trim panels.

Do not mount the amplifier in an inverted or upside

down position.

Check all locations and placements carefully before

making any cuts, drilling any holes or making any

connections.

CA20, 21, 40 & 50