User Guide

CONNECTION OF Reference 200A
- 14 -
6.5 Connection of a 3-way system
using active crossover between
woofer and midrange.
You can use all DLS 3-way systems in this
example. For example DLS R 36, UP35, UP36 or
similar.
Speaker impedance must be 4 ohm.
If the head unit has only one pre out a Y-cable
must be used.
For power cable, speaker cable and fuse size
selection we refer to section 2.2 - 2.4
Battery
12 volt
25
FUSE PROTECT POWER
25 A x 2
25
POWER INPUT
GND RMT BATT
Fuse
40 A
To remote
on head unit
FM1 101,9
2,5V
15 200
70 90
50 200 5,5V 0,3V
OUT
HP-filter LP-filter LP-filter LEVEL
IN
SPEAKERS
+LEFT- +RIGHT-
+ BRIDGE -
SIGNAL INPUT
LEFT RIGHT
2,5V
15 200
70 90
50 200 5,5V 0,3V
OUT
HP-filter LP-filter LP-filter LEVEL
IN
SPEAKERS
+LEFT- +RIGHT-
+ BRIDGE -
SIGNAL INPUT
LEFT RIGHT
HP-filter LP-filter LP-filter LEVEL
IN
OUT
15 200 50 200
70 90
5,5V 0,3V
2,5V
+
+-
-
+
+
-
-
Button out
Pre out
front
Pre out
rear
Button in
HP-filter LP-filter LP-filter LEVEL
IN
OUT
15 200
70 90
5,5V 0,3V
2,5V
50 200
+
+-
-
Passive high-
pass filter to
the tweeters
Mid
range
Subwoofers
Mid
range
Tweeters
Passive crossover is used for the tweeters
The crossover frequency between woofer and
midrange is 200 Hz.