User Guide

CONNECTION OF Reference 200A
- 13 -
6.4 Connection of a front systerm in
stereo connected in bridge mode on
all four channels.
You can use all DLS coaxial, 2-way or 3-way
speaker systems in this example. Speaker
impedance must be 4 ohm.
If the head unit has only one pre out a Y-cable
must be used.
For power cable, speaker cable and fuse size
selection we refer to section 2.2 - 2.4
+
-
Battery
12 volt
25
FUSE PROTECT POWER
25 A x 2
25
POWER INPUT
GND RMT BATT
Fuse
40 A
To remote
on head unit
FM1 101,9
2,5V
15 200
70 90
50 200 5,5V 0,3V
OUT
HP-filter LP-filter LP-filter LEVEL
IN
SPEAKERS
+LEFT- +RIGHT-
+ BRIDGE -
SIGNAL INPUT
LEFT RIGHT
2,5V
15 200
70 90
50 200 5,5V 0,3V
OUT
HP-filter LP-filter LP-filter LEVEL
IN
SPEAKERS
+LEFT- +RIGHT-
+ BRIDGE -
SIGNAL INPUT
LEFT RIGHT
+
-
The drawing shows how to connect a stereo system
in bridge mode on all four channels.
Button out Button out
HP-filter LP-filter LP-filter LEVEL
IN
OUT
15 200 50 200
70
90
5,5V 0,3V
2,5V
HP-filter LP-filter LP-filter LEVEL
IN
OUT
15 200 50 200
70 90
5,5V 0,3V
2,5V
Pre out
front
Pre out
rear