User Guide

CONNECTION OF Reference 200A
- 11 -
6.2 Connection of a front system in
stereo and a subwoofer in mono
bridge mode.
You can use all DLS coaxial, 2-way or 3-way
speaker systems in this example. Speaker
impedance must be 4 ohm.
If the head unit has only one pre out a Y-cable
must be used.
For power cable, speaker cable and fuse size
selection we refer to section 2.2 - 2.4
+
+-
-
Subwoofer
4 ohm
Battery
12 volt
25
FUSE PROTECT POWER
25 A x 2
25
POWER INPUT
GND RMT BATT
Fuse
40 A
To remote
on head unit
FM1 101,9
2,5V
15 200
70 90
50 200 5,5V 0,3V
OUT
HP-filter LP-filter LP-filter LEVEL
IN
SPEAKERS
+LEFT- +RIGHT-
+ BRIDGE -
SIGNAL INPUT
LEFT RIGHT
2,5V
15 200
70 90
50 200 5,5V 0,3V
OUT
HP-filter LP-filter LP-filter LEVEL
IN
SPEAKERS
+LEFT- +RIGHT-
+ BRIDGE -
SIGNAL INPUT
LEFT RIGHT
+
+-
-
Front
Rear
You can connect one or two systems in stereo to
the speaker terminals. These are connected in
parallel.
Button in Button out
HP-filter LP-filter LP-filter LEVEL
IN
OUT
15 200 50 200
70
90
5,5V 0,3V
2,5V
HP-filter LP-filter LP-filter LEVEL
IN
OUT
15 200 50 200
70 90
5,5V 0,3V
2,5V
Pre out
front
Pre out
rear