User manual

ASURO - 27
-
If an optical connection between ASURO and the Infrared-Transceiver has been arranged (which
requires a maximal distance of ca. 50 cm), the terminal program will show up a symbol ‘T’ regularly
or alternatively the button you may have activated at the PC’s keyboard (as it has been transmitted
by the transceiver), followed by the symbol next in the alphabet, eg.:
Key “e” is activated
→
terminal program reports “ef”
Key “j” is activated
→
terminal program reports “jk”
Key “3” is activated
→
terminal program reports “34”
In case of errors see chapter 6.9.
5.3.7. ready ?
If an error has occurred, switch the system OFF and remove the batteries. Trace and eliminate the
error by methods in chapter 6 . Repeat the selftest to see if no component has been damaged.
Only a completed and errorfree selftest will guarantee the ASURO hardware is OK and that any
other errors will have to be found in the software.
If you have to check the hardware after you have installed other programs in ASURO, the selftest
program “SelfTest.hex” has to be reloaded and programmed from CD.
Fully assembled ASURO
Electronics