User's Manual

ManualsBrandsDLP Design ManualsElectronicsRFID Device

www.dlpdesign.com sales@dlpdesign.com  2008 (Preliminary Data)

DLP-RFID2

FEATURES:

• ISO 15693, 18000-3, Tag-it™ HF-I Compatible

• Read the UID/SID of Up To 15 Tags Simultaneously

• 13.56MHz Reader/Writer

• U.FL external antenna connector

• On-board internal antenna

• FCC/IC Modular Approvals Pending

• Powered by 3.0 to 5.0 Volt Supply

• TTL Serial Interface at 115200 baud

• Operating Temperatures: 0°C to 70°C

• Dimensions: (L x W x H) 1.65” x 0.735” x 0.17”

APPLICATIONS:

• Real-Time Security

• Personal Identification

• Pharmaceutical Tracking

• Inventory/Asset Management & Tracking

• Library/Book Management & Tracking

• Baggage Tagging

• Sports Event Timing

1.0 INTRODUCTION

The DLP-RFID2 is a low-cost, compact module for reading from and writing to ISO 15693, ISO

18000-3, and Tag-it™ intelligent RFID transponder tags via an internal or an external antenna.

It has the ability to both read and write up to 256 bytes of data in addition to reading the unique

identifier (UID/SID). All of the DLP-RFID2’s electronics reside on a single compact PCB, and all

operational power is taken from a single 3.0 to 5.0 volt supply. An external antenna can be

connected via standard u.fl connector.

2.0 APPLICATION DEVELOPMENT

Demonstration “C” source code is available (upon purchase) that demonstrates the

communications protocol as developed for a microcontroller.

Summary of content (4 pages)

PAGE 1
DLP-RFID2 FEATURES: • • • • • • • • • • ISO 15693, 18000-3, Tag-it™ HF-I Compatible Read the UID/SID of Up To 15 Tags Simultaneously 13.56MHz Reader/Writer U.FL external antenna connector On-board internal antenna FCC/IC Modular Approvals Pending Powered by 3.0 to 5.0 Volt Supply TTL Serial Interface at 115200 baud Operating Temperatures: 0°C to 70°C Dimensions: (L x W x H) 1.65” x 0.735” x 0.
PAGE 2
3.0 REGULATORY AGENCY CONSIDERATIONS 3.1 AGENCY IDENTIFICATION NUMBERS Compliance with the appropriate regulatory agencies is essential in the deployment of all transceiver devices. DLP Design is in the process of obtaining modular approval for this RF product such that an OEM need only meet a few basic requirements in order to utilize their end product under this approval. Corresponding agency identification numbers are listed below: Part Number US/FCC CAN/IC DLP-RFID2 SX9RFID2 5675A-RFID2 3.
PAGE 3
responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization. 3.5 OEM PRODUCT LABELING The final end product must be labeled in a visible area with the following text: “Contains TX FCC ID: SX9RFID2” 3.6 RF EXPOSURE In order to comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 3.
PAGE 4
5.0 CONTACT INFORMATION DLP Design, Inc. 1605 Roma Lane Allen, TX 75013 Phone: Fax: Email: Internet: 469-964-8027 415-901-4859 support@dlpdesign.com http://www.dlpdesign.com www.dlpdesign.com sales@dlpdesign.