User's Manual

This device is intended for use under the following conditions:

1. The transmitter module may not be co-located with any other transmitter or antenna.

2. The module is approved using the FCC “unlicensed modular transmitter approval” method.

As long as these two conditions are met, further transmitter testing will not be required.

However, the OEM integrator is still responsible for testing their end product for any additional

compliance measures necessitated by the installation of this module (i.e. digital device

emissions, PC peripheral requirements, etc.).

Note: In the event that these conditions cannot be met (i.e. co-location with another

transmitter), then the FCC authorization is no longer valid and the corresponding FCC ID may

not be used on the final product. Under these circumstances, the OEM integrator will be

responsible for re-evaluating the end product (including the transmitter) and obtaining a

separate FCC authorization.

3.5 OEM PRODUCT LABELING

The final end product must be labeled in a visible area with the following text:

“Contains TX FCC ID: SX90LP8C”

3.6 RF EXPOSURE

In order to comply with FCC RF exposure compliance requirements, the antenna used for this

transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

3.7 ADDITIONAL INFORMATION FOR OEM INTEGRATORS

The end user should NOT be provided with any instructions on how to remove or install the

DLP-RFID-LP8C. This device has been certified to operate with the antenna models listed

below:

DLP Design Large Loop Antenna

DLP Design Small Loop Antenna

DLP Design Ferrite Antenna

4.0 DISCLAMER

Neither the whole nor any part of the information contained herein nor the product described in

this datasheet may be adapted or reproduced in any material or electronic form without the prior