User's Manual

3.0 REGULATORY AGENCY CONSIDERATIONS

3.1 AGENCY IDENTIFICATION NUMBERS

Compliance with the appropriate regulatory agencies is essential in the deployment of all

transceiver devices. DLP Design is in the process of obtaining modular approval for this RF

product such that an OEM need only meet a few basic requirements in order to utilize their end

product under this approval. Corresponding agency identification numbers are listed below:

Part Number US/FCC CAN/IC

DLP-RFID-

LP8C

SX90LP8C 5675A-0LP8C

3.2 EXTERNAL ANTENNAS

The DLP-RFID1 is approved for use with external antennas.

3.3 FCC/IC REQUIREMENTS FOR MODULAR APPROVAL

Any changes or modifications to the DLP-RFID-LP8C’s printed circuit board could void the

user’s authority to operate the equipment. Operation of an unapproved antenna could void the

user’s authority to operate the equipment.

3.4 WARNINGS

Operation is subject to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received, including interference

that may cause undesirable operation.

To reduce potential radio interference to other users, the antenna type and its gain should be so

chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted

for successful communication.