Specifications

Section II – Application and Operation (continued)
Special function 1-24 outputs.............................................................................2-27
Detector simulation outputs ...............................................................................2-27
General coordination outputs.............................................................................2-28
Circuit 13............................................................................................................2-28
System...............................................................................................................2-28
Coordination clock CKT’s 1-8, 13 ......................................................................2-28
Cycle 2, 3 out (ckt 1,2).......................................................................................2-28
Time clock offset 1, 2, 3 out ...............................................................................2-28
Split 2, 3 out (ckt 6, 7)........................................................................................2-28
Output circuit 8 (call for remote flash) .....................................................................2-29
Output circuits 9, 10, 11, 12...............................................................................2-29
Mappable inputs and outputs .......................................................................................2-29
External harnesses .................................................................................................2-29
Section III – Displays and Run Mode
Introduction................................................................................................................... 3 - 1
Power on self test (post) ......................................................................................... 3-1
MSA I/O Mode......................................................................................................... 3-1
Standard displays.................................................................................................... 3-1
Run mode..................................................................................................................... 3-2
Function keys ............................................................................................................... 3-2
Run screen “hot keys” ............................................................................................. 3-2
Entering vehicle calls, ped calls, and pre-empt calls from run status screens......... 3-2
Vehicle calls....................................................................................................... 3-2
Pedestrian calls ................................................................................................. 3-2
Pre-empt calls.................................................................................................... 3-2
Run mode screens.................................................................................................. 3-3
Run screen faults.......................................................................................................... 3-4
Run screen fault list................................................................................................. 3-4
Controller MMU faults ........................................................................................ 3-4
Power on self test faults..................................................................................... 3-4
Checksum faults ................................................................................................ 3-4
Coordination timing display .......................................................................................... 3-5
Coordination mode display ........................................................................................... 3-5
Volume density status display ...................................................................................... 3-6
Time clock event status ................................................................................................ 3-6
I/O status ...................................................................................................................... 3-6
I/O modes display ................................................................................................... 3-7
Phase input status display....................................................................................... 3-7
Phase outputs display ............................................................................................. 3-8
Ring/unit status display ........................................................................................... 3-8
Pre-empt I/O status display..................................................................................... 3-9
Detectors ...................................................................................................................... 3 - 9