Specifications

Copyright Peek Traffic Systems Incorporated, 2000
24
I/O CONFIGURE ______
Base Configuration Mode (0 = TS1, 1-5 = Type 2 modes 1-5, 8 = Type 1)
PORT 1 BIU/MMU OPTIONS
BIU ENABLES (MM-4-1-1)
T/F BIU 1 2 3 4 5 6 7 8
///////////////
DET BIU 9 10 11 12 13 14 15 16
///////////////
ON/OFF; ON = BIU position enabled T/F= Terminal & Facilities (load sw’s)
PORT 1 OPTIONS (MM-4-1-2)
PEER TO PEER ON = Peer to Peer (other unit)
MMU DISABLE ON = Port 1 disabled (TS1 mode)
TYPE 2 RUN AS TYPE 1 ON = BIU’s instead of MSA, B. C
PHASE TO LOAD SWITCH (MMU CHAN) ASSIGN (MM-4-1-3)
PHASE 1 2 3 4 5 6 7 8
CHANNEL
OVERLAP A B C D
CHANNEL
PED 1 2 3 4 5 6 7 8
CHANNEL
Range; 1-16. Assigns MMU channel 1-16 to each phase, O/L, Ped
PEER TO PEER POLLING ADDRESSES (MM-4-1-4)
NOTES
CUSTOM INPUT MAPPING (MM-4-2-3-PgDn, etc.)
VEH DETECTORS 1-8
INP FUNC VD1 VD2 VD3 VD4 VD5 VD6 VD7 VD8
PIN #
LOGIC
PIN #
VEH DETECTORS 9-16
INP FUNC VD9 VD10 VD11 VD12 VD13 VD14 VD15 VD16
PIN #
LOGIC
PIN #
VEH DETECTORS 17-24
INP FUNC VD17 VD18 VD19 VD20 VD21 VD22 VD23 VD24
PIN #
LOGIC
PIN #
VEH DETECTORS 25-32 (currently not supported, DO NOT PROGRAM)
INP FUNC VD25 VD26 VD27 VD28 VD29 VD30 VD31 VD32
PIN # 0 0 0 0 0 0 0 0
LOGIC OR OR OR OR OR OR OR OR
PIN # 0 0 0 0 0 0 0 0
PED DETECTORS 1-8
INP FUNC PED
1
PED
2
PED
3
PED
4
PED
5
PED
6
PED
7
PED
8
PIN #
LOGIC
PIN #
PHASE HOLD 1-8
INP FUNC HLD1 HLD2 HLD3 HLD4 HLD5 HLD6 HLD7 HLD8
PIN #
LOGIC
PIN #
Note: Blanks = Standard default mode, make entries by exception only