Specifications

SPECIAL INTERVALS (MM-2-5-7) (BLANK = DEFAULT = CODE 5 = RED)

SPEC. INTERVAL PH1 PH1 PH2 PH3 PH4 PH5 PH6 PH7 PH8 OL A OL B OL C OL D

Phase and Overlap color codes 0 = Dark 3 = Flashing Don’t Walk 6 = Flash Yellow Wig 9 = Flash Red Wag

1 = Green/dw 4 = Yellow 7 = Flash Yellow Wag . = Fast Flash green

2 = Green/walk 5 = Red 8 = Flash Red Wig

Notes: 1. “Wig” and “Wag” are 180 degrees out of phase w/each other

2. Must enter special intervals from all red, i.e. “90” code must

precede first special interval. The last interval must be all 5’s.

HI PRIORITY PRE-EMPT SET-UP

PE MEMORY/DELAY/RE-SERVICE (MM-2-5-8-1)

PE INPUT 1 2 3 4 5 6

MEMORY (ON/OFF)

DELAY BEFORE PE

MIN RESEVICE

Delay Range = 0-255 Seconds, Reservice = 0 - 99 Minutes

PE OVERLAP INHIBITS (MM-2-5-8-2)

PE INPUT 1 2 3 4 5 6

Use 4 digit code for each input in order of ABCD

0 = Allow normal overlap

1 = Inhibit overlap on entry into and during pre-empt

Example: 0100 = Inhibit OL/B

PRE-EMPT ENTRY TIMES (MM-2-5-8-3)

PE INPUT MGR WLK PCL OLY OLR FDW/Y

Range: 0 - 9.9 or 127 for MGR, WLK, PCL, OLY, OLR. FDW/Y = ON OFF

Note:

“0” for MGR, WLK, PCL = Use normal phase time values. Thus, “.1” is the

shortest programmable PE entry time for these values.

OLY, OLR = Overlap yellow & red time when OL must time its own clearance.

FDW/Y= ON = Allow Don’t Walk to flash through yellow on entry into P

PRE-EMPT PRIORITIES (MM-2-5-8-4)

PE INPUT 1 2 3 4 5 6

PRIORITY

OVERRIDE FLASH

Priority = 1-6 (1 = highest, 6 = lowest). When equal, 1st come 1st serve.

Override Flash = ON/OFF. ON = Exit remote (UCF) flash for pre-empt.