Specifications

11-8
When selected….the following screen will be displayed
As the above screen indicates, any and all I/O
configuration changes will be implemented, including
signal outputs. USE CAUTION when doing so in the
field.
If ENTER is pressed, the following screen will be
displayed to indicate the changes have been made.
Hit PRIOR MENU to return to the I/O Configuration
menu.
PIN-OUTS
Pin-outs are defined in terms of the TS2 I/O mode
select bits A B and C.
TS2 mode configurations are selected by TS2 type 2
I/O mode bit input pins A, B, C as follows;
I/O mode Input A = A-q
I/O mode Input B = A-y
I/O mode Input C = A-HH
An asterisk under Mode indicates that the fucntion is
not mode dependent and does not change from mode
mode to mode.
NOTE: Only modes 0-2 are defined in the LMD. Modes
4-7 are future and are not defined at this time.
WARNING! THE CONTROLLER WILL REMAP
ALL INPUTS AND OUTPUTS TO RFLECT
ANY CHANGES MADE. BE CAREFUL
–-ENTER TO REMAP—PRIOR MENU TO CANCEL--
--I/O CONFIG CHANGES LOADED—
-PRIOR MENU-
Selection State table Inputs are DC gnd = ON
Mode
A B C State
0 Off Off Off TS1 Mode
1 On Off Off TS2 Hardwire Inter.
2 Off On Off TS2 System