Specifications

Section X – Back-Up Timing Plans (continued)
5 Phase force offs ...................................................................................................10-8
5 Phase permissives ...............................................................................................10-8
6 Phase plan ................................................................................................................10-9
6 Phase controller data ...........................................................................................10-9
6 Phase coordination data ......................................................................................10-9
Cycles and offsets...................................................................................................10-9
6 Phase force offs ...................................................................................................10-9
6 Phase permissives ...............................................................................................10-9
8 Phase plan ................................................................................................................10-10
8 Phase controller data ...........................................................................................10-10
8 Phase coordination data ......................................................................................10-10
Cycles and offsets...................................................................................................10-10
8 Phase force offs ...................................................................................................10-10
8 Phase permissives ...............................................................................................10-10
Section XI – Input/output
General.........................................................................................................................11-1
BIU (Bus interface unit) ................................................................................................11-1
MMU (Malfunction management unit)...........................................................................11-1
TS-2 ports.....................................................................................................................11-1
Port 1 – SDLC (Synchronous data link control).......................................................11-1
Port 2 – RS-232C (25 pin).......................................................................................11-1
Port 3 – System interface communications port (9 pin)...........................................11-2
I/O configure.................................................................................................................11-2
Port 1/BIU/MMU options .........................................................................................11-2
BIU enable.........................................................................................................11-2
Port 1 options.....................................................................................................11-2
Peer to peer polling enable................................................................................11-2
MMU disable......................................................................................................11-2
Run Type 2 as Type 1 .......................................................................................11-3
Phase to load switch..........................................................................................11-3
Peer addresses..................................................................................................11-3
Custom I/O mapping.....................................................................................................11-3
Standard TS-2 Type II I/O configurations................................................................11-3
Mode dependent inputs and outputs.......................................................................11-4
New (TS-2 Type 2) inputs .......................................................................................11-4
I/O mapping.............................................................................................................11-4
I/O default modes (back-up plans) ..........................................................................11-4
Virtual outputs .........................................................................................................11-5
Custom input mapping procedure ...........................................................................11-5
Input programming instructions...............................................................................11-6
“AND”ing, “OR”ing, and “NOT” ing of inputs............................................................11-6
Custom output mapping procedure.........................................................................11-7