Specifications

DLI 8800 PRODUCT MANUAL PAGE 36/44 Rev. 4
Installing the Vehicle Mount Cradle
Mounted to the back panel of the Vehicle Cradle is a RAM-202U ball. RAM mounting arms are
available for a variety of secure options. When selecting a location to mount the cradle, keep in
mind that the power supply, RF connectors and I/O point straight out of the back panel.
Please ensure that you give a minimum of 2.75 inches of clearance from the
base and back of the cradle. Proper cable routing and clearance will help with
less strain on cables and connectors, while also allowing for better access to
the ports.
Cradle Power Filtering DC Converter
The DLI 8800 Cradle has an optional 10~60V DC/DC Converter. The DLI 8800 Cradle must be
installed pre-ignition (directly to battery terminals) with a 10AMP in-line fuse. Failure to
connect to battery terminals could damage the power conversion circuitry.
Please consult your fork truck manufacturer for proper installation instructions.
DO NOT connect power to the hydraulics!
We recommend installation by trained service personnel only. The fuse should
be installed in the positive lead within 5 inches of the battery positive (+)
terminal.
DC Converter: 10~60V Input
Red
Positive
Black
Tie
together
Ground
Yellow
RAM-202U Ball
K-Lock
Side Panel
Back Panel
Power Port, RF
and I/O Connectors
Power Port
GPS
Serial
Port
FME
WiFi
USB
J-BUS
USB