Owners manual
7
The result indicates the battery is good and full of 100% of life. But only
12.11V left. SO suggest charging.
Life check OK, and voltage check over low
The result indicates the battery is OK and remains 73% of life. But only
11.88V left and over low voltage, which can affect the result. At this time it is
better to charge prior to checking again.
5-3 engine system activation load test
5-3-1preparation
If the engine is working, please turn off first and switch the key to off
location.
5-3-2 procedure of operation
(1) Connect the red clamp to the positive polar of the battery, and the black
one to the negative polar. Make sure they are well connected in order to avoid
affected result.
(2) Press <▲><▼>to select activation load test as the picture below:
(3) After selecting the test item, press <ENTER> to display the activation load
test screen as the picture below:
14
The load test method: According to the physical formula R=V/1, test
equipment forcibly make the high permanent DC current ( presently 40-80A
large current is available ) go through the battery shortly ( about 2-3
seconds). And then the tested voltage of the battery can be used to figure out
the internal resistance by the formula.
(1) Just available for large capacitance battery or storage battery. The small
capacitance battery can not load 40-80A large current in 2-3 seconds.
(2) When the large current going through the battery, there comes out
polarization phenomenon from internal electrode, which can cause
polarization internal resistance. As a result it has to be tested in a short time.
Otherwise there is a large error of the internal resistance value.
(3) The internal electrode will be damage generally when large current go
through the battery.
The method of this tester:Battery is actually equivalent to an active
resistance. So we add a fixed frequency and small current to it, and then
sample the voltage value. Eventually the internal resistance can be figured
out after some operation such as rectificationand smoothing.
7. Specification Of Storage Battery
The data in the table is just for reference. Actual value must be referredto the
manufacturer.
7-1．JIS translation table
Batt e r y
CCA Batt e r y
NEW JI S OLD J I S M F C M F N E W J I S OL D J I S MF CMF
26A1 7 R 2 00 5 5 B 2 4 R S N T 8 0-S 6 S 43 0 4 2 0 50 0
26A1 7 L 2 00 5 5 B 2 4 L S N T 80-S 6 L S 4 3 0 4 2 0 500
26A1 9 R 1 2 N 2 4-4 200 22 0 26 4 5 5 D2 6 R N5 0 Z 3 5 0 4 4 0 525
26A1 9 L
12N2 4-3 2 0 0 22 0 26 4 5 5 D 2 6 L N 5 0 Z L 35 0 440 52 5
28A1 9 R N T 5 0-N 2 4 2 5 0 60 D 2 3 R 52 0
28A1 9 L NT 5 0-N 2 4 L 2 5 0 60 D2 3 L 5 2 0
32A1 9 R N X 6 0-N 24
270
65D2 3 R
420
540 58 0
CCA
295