User guide

8
device script commands
The following commands are supported in the script that will be downloaded to the CPE via TFTP during
boot-up process.
Thiscommandisusedtoconguretheswitchintheunit.Thecommandtakesoneormoreofthefollow-
ing parameters, with the syntax switch --nn.
The 7960x models have 4 LAN ports, whereas 7961x models have 7/8 LAN ports. The port outline and port
mapping is as follows, shown from the front:
4 port (7960x):
LAN1
1
LAN2
2
LAN3
3
LAN4
4
7 port (79615, 79616):
LAN2
2
LAN4
4
LAN6
Ext2
LAN8
Ext4
X
(WiFi)
LAN3
3
LAN5
Ext1
LAN7
Ext3
8 port (79611/12/13/14):
LAN2
2
LAN4
4
LAN6
Ext2
LAN8
Ext4
LAN1
1
LAN3
3
LAN5
Ext1
LAN7
Ext3
LAN ports 5 – 8 are activated by the –ext command, e.g.
--set-port-mtu=PORT:(0|1|2), where port is 1…4, covering LAN1…4
--set-port-mtu-ext=PORT:(0|1|2), where port is 1…4, covering LAN5…8
Basic settings:
-s, --simple-switch
Setup port based VLAN for a simple switch.
-e, --enable-lan
Enables LAN ports so traffic can be switched between WAN and LAN.
-v, --version
Prints the firmware version number.
-h, --help
Prints this help text.
--set-arp-mirroring=PORT:enable
Enable/disable ARP mirroring to the CPU port, works from firmware revision
02_13 and later
--get-arp-mirroring=PORT
Get state of ARP mirroring to the CPU port, works from firmware revision 02_13
and later