User guide

61
ipbx fc no answer forward enable Call forward when no answer - number
follows
92
ipbx fc no answer forward disable Cancel call forward when no answer 93
ipbx fc busy forward enable Call forward when busy - number follows 94
ipbx fc busy forward disable Cancel call forward when busy 95
ipbx outgoing block enable 96
ipbx outgoing block disable 97
ipbx fc unattended transfer 98
built-in wifi (for 79615 and 79616)
Important:
TheWiAccessPointusestheLANport1asinterface,soallCPEswitchrelatedsettingsmadeforLAN
port 1 will be applicable to this interface. 79615 and 79616 do not have LAN port 1 available for other
servicesthanwi.
tftp based provisioning
TheWiAccessPointwillgetitscongurationviaaTFTPrequestinitiatedbytheCPE,whenthemodule
is present and enabled.
ThemoduleisenabledusingthefollowingcommandintheCPEcongurationscript.
enable_wifi <host-wifi-setup-filename> [-t optional-TFTP-server-IP] [-p option-
alpassword] [-w optional-WiFi-IP-address]
# The default password for the admin user is “admin”. If the password is
changed, this new password may be supplied as the second parameter on the com-
mand line. The default IP address of the wifi module is 192.168.1.250. If this
is changed, then both the password and the correct IP address must be supplied
on the command line. The default TFTP server is the same as used for the CPE
configuration file.
system parameters
CongurationoftheWiAccessPointisdonewiththeuseofacongurationle,includingthefollowing
parameters,pleaserefertoAppendix2–Wicongurationlefordetails.
Parameter Description Default
Default Do not touch -
WebInit Do not touch 1