User guide

20
issuing the command:
switch --enable-lan
set lan port speed
Allportsaredefaultconguredto1000Mbit/sfullduplex.Changeofthissettingispossiblebyusingthe
following command:
switch --set-port-speed-mode=<port>:<mode>
# <port> is 0, 1, 2, 3, or 4
# <mode> is 1000FD|1000HD|100FD|100HD|10FD|10HD|AUTO
# applicable to 7/8 port models only
switch --set-port-speed-mode-ext=<port>:<mode>
# <port> is 1, 2, 3, or 4, covering LAN port 5, 6, 7, or 8
# <mode> is 1000FD|1000HD|100FD|100HD|10FD|10HD|AUTO
set port mtu size
The MTU size can be programmed for each port. The following syntax can be used:
switch --set-port-mtu=[PORT]:[Jumbo Mode]
#Where [PORT] is 0…5
# applicable to 7/8 port models only
switch --set-port-mtu-ext=[PORT]:[Jumbo Mode]
#Where [PORT] is 1…4
#Where [Jumbo Mode] = 0 for 1522 bytes, 1 for 2048 bytes and 2 for 10240 bytes
igmp snooping
The device supports IGMP snooping, and join messages received from clients on the LAN ports will be
handled by the CPE CPU, which will control which ports that belongs to which multi cast group. IGMP
snooping has to be enabled per port but is running per default:
# Enable IGMP snooping on port 2, 3, 6 and 8
switch --enable-port-igmp-snooping=2:1
switch --enable-port-igmp-snooping=3:1
# applicable to 7/8 port models only
switch --enable-port-igmp-snooping-ext=2:1
switch --enable-port-igmp-snooping-ext=4:1
# Also unknown multicast traffic should be blocked. This can be done via the