User guide

--get-port-default-vid=PORT:VID

Prints the default VLAN ID(VID) for a port.

--get-port-default-vid-ext=PORT:VID

Prints the default VLAN ID(VID) for a port.

Applicable to 7/8 port models only. Port 1…4 covers LAN port 5…8.

--set-port-force-default-vid=PORT:ENABLE

Forces the tagging of VID on all frames on the port.

--set-port-force-default-vid-ext=PORT:ENABLE

Forces the tagging of VID on all frames on the port.

Applicable to 7/8 port models only. Port 1…4 covers LAN port 5…8.

--get-port-force-default-vid=PORT

Gets the status of force tagging of VID on all frames on the port.

--get-port-force-default-vid-ext=PORT

Gets the status of force tagging of VID on all frames on the port.

Applicable to 7/8 port models only. Port 1…4 covers LAN port 5…8.

--set-port-802dot1q-mode=PORT:MODE

--set-port-802dot1q-mode-ext=PORT:MODE

Applicable to 7/8 port models only. Port 1…4 covers LAN port 5…8.

Sets the IEEE 802.1Q mode for the ingress port.

Mode either

0=disable, disables IEEE 802.1Q for the port, used for port based VLANs

1=fallback, enables IEEE 802.1Q for the port, fallback mode

2=check, enables IEEE 802.1Q for the port, check mode

3=secure, enables IEEE 802.1Q for the port, secure mode

--get-port-802dot1q-mode=PORT

--get-port-802dot1q-mode-ext=PORT

Applicable to 7/8 port models only. Port 1…4 covers LAN port 5…8.

Prints the 802.1Q mode for the ingress port.

Mode either

0=disable, disables IEEE 802.1Q for the port, used for port based VLANs

1=fallback, enables IEEE 802.1Q for the port, fallback mode

2=check, enables IEEE 802.1Q for the port, check mode

3=secure, enables IEEE 802.1Q for the port, secure mode

Port based VLAN:

--set-port-vlan-table=port:WAN_ENABLE:LAN1_ENABLE:LAN2_ENABLE: LAN3_

ENABLE:LAN4_ENABLE:CPU_ENABLE

Enable which ports are enabled for communication.

PORT_ENABLE is in the range 0..1

--set-port-vlan-table-ext=port:WAN_ENABLE:LAN1_ENABLE:LAN2_ENABLE: LAN3_

ENABLE:LAN4_ENABLE:CPU_ENABLE:LAN5_ENABLE:LAN6_ENABLE:LAN7_ENABLE:LAN8_ENABLE

Enable which ports are enabled for communication.

PORT_ENABLE is in the range 0..1

Applicable to 7/8 port models only.

--get-port-vlan-table=port