User guide

11
Flow control:
--enable-port-flowcontrol=PORT:(1|0)
Enables/disables flow control on the port
--enable-port-flowcontrol-ext=PORT:(1|0)
Enables/disables flow control on the port
Applicable to 7/8 port models only. Port 1…4 covers LAN port 5…8.
--get-enable-port-flowcontrol=PORT:(1|0)
Prints the status of flow control on the port
--get-enable-port-flowcontrol-ext=PORT:(1|0)
Prints the status of flow control on the port
Applicable to 7/8 port models only. Port 1…4 covers LAN port 5…8.
Rate control:
--dump-pirl-buckets
Prints the status of the PIRL buckets.
--set-port-egress-rate-limit=PORT:rate
Sets the egress rate for the port. Rate is in kbps range: 0, 128..1000000 -
0=unlimited
--set-port-egress-rate-limit-ext=PORT:rate
Sets the egress rate for the port. Rate is in kbps range: 0, 128..1000000 -
0=unlimited
Applicable to 7/8 port models only. Port 1…4 covers LAN port 5…8.
--get-port-egress-rate-limit=port
Display egress rate for the port.
--get-port-egress-rate-limit-ext=port
Display egress rate for the port.
Applicable to 7/8 port models only. Port 1…4 covers LAN port 5…8.
--set-port-ingress-rate-limit=port:bucket:rate:layer:(DROP|FC)
Sets a Port Input Rate Limit(PIRL) bucket.
--set-port-ingress-rate-limit-ext=port:bucket:rate:layer:(DROP|FC)
Sets a Port Input Rate Limit(PIRL) bucket.
Applicable to 7/8 port models only. Port 1…4 covers LAN port 5…8.
--get-port-ingress-rate-limit=port
Gets a list of enabled Port Input Rate Limit(PIRL) buckets.
--get-port-ingress-rate-limit-ext=port
Gets a list of enabled Port Input Rate Limit(PIRL) buckets.
Applicable to 7/8 port models only. Port 1…4 covers LAN port 5…8.
--disable-pirl-bucket=port:bucket
Disables a PIRL bucket.
--disable-pirl-bucket-ext=port:bucket
Disables a PIRL bucket.
Applicable to 7/8 port models only. Port 1…4 covers LAN port 5…8.