Owner`s manual

3.2.4 Open Tone On or Off
The following programming sequence turns the open tone (when the relays activate) either On or Off.
This feature is available on Rev J boards or higher.
NOTE: The tone open on/off cannot be programmed from an off-site location. This setting can
only be programmed from the system keypad.
Factory setting = 1 (tone on)
1. Press * 1 5 and then enter the four digit master code _ _ _ _ (beep).
2. Enter 1 for yes (tone will sound) or 0 for no (tone will not sound) then press * (beep).
3. Press 0 # together to end this programming sequence (beeeeeep).
3.2.5 Elevator Control Function
This new elevator feature authorizes floor access to the Floor Level identified in the Resident Screen
in the software program AND to the floor(s) level identified in the Security Level screen. If this feature
is turned off, access will be granted only the floor identified in the user’s security level. This feature is
available on Rev J boards or higher.
NOTE: This elevator control function cannot be programmed from an off-site location. This
setting can only be programmed from the system keypad.
Factory setting = 1 (new elevator function is turned on)
1. Press * 7 5 and then enter the four digit master code _ _ _ _ (beep).
2. Enter 1 for yes (access is authorized to both the floor identified in the resident screen and
to the floor(s) identified in the user’s security level) or 0 for no (access is authorized only
to the floor(s) identified in the security level screen) then press * (beep).
3. Press 0 # together to end this programming sequence (beeeeeep).
STOP!!
If the access control system is to be programmed from a PC, no other programming is required at the
system itself. Refer to the Remote Account Manager for Windows software manual for additional
programming information. Continue with the remaining sections in this chapter if the system will be
programmed from the keypad. If the factory setting matches your need, there is no reason to
reprogram that section. Remember that relay hold open time zones, security levels, and elevator
control functions can only be programmed from the Remote Account Manager software. If any of
these features are being used, do not proceed with any other programming steps in this manual.
Page 26 1838-065-J-6-08