Troubleshooting guide

Chapter 4 - Installation & Wiring 41
April 1998 Rev. 1
4.5.9 TS310 to HSC3 Hydraulic Actuator Wiring
The HSC3 Hydraulic Actuator should be connected as shown in the figure below. A 0 to 2 inch
position signal is available on the green wire and optionally may be connected as an analog input for
position readout.
- +
20
40
COM
WHITE
BLACK RED
WHITE
COMMAND
4-20 mA
+15 V GND
TWISTED
SHIELDED PAIR
TS310
FIELD
TO SHIELD TERMINAL STRIP
ANALOG OUTPUT
TWISTED
SHIELDED PAIR
TWISTED
PAIRS
SPLICE IN
CONDUIT
TS310-22
- +
ANALOG INPUT
HSC3
TO SHIELD
TERMINAL
STRIP
GREEN
POSITION
FEEDBACK
(OPTIONAL)
TERMINATE SHIELD -
NO CONNECTION
NOTE : DO NOT MIX WHITE
WIRES BETWEEN PAIRS.
ACTUATOR COULD BE
DAMAGED
Figure 27. TS310 to HSC3 Hydraulic Actuator Wiring
HSC3 FORCE AVAILABLE
Pressure Lbs Stall Velocity at 1/2 Stall
100 180 5 inches per second
400 720 10 inches per second
1000 1800 14 inches per second
NOTE: Refer to paragraph 10.14 for a discussion of testing the output.