Technical data

Chapter 4 Digital output modules Manual VIPA System 200V
4-14 HB97E - SM - Rev. 09/19
222-1BH00 - DO 16xDC 24V 0.5A with UB4x
DO 16xDC 24V 0.5A VIPA 222-1BH00
The digital output module accepts binary control signals from the central
bus system and transfers them to the process level via outputs. The
module requires 24V via the connector on the front. It has 16 channels and
the status of each channel is displayed by means of an LED. This module
requires a converter (DEA-UB4x). The module must be connected to the
converter module by means of a flattened round cable (DEA-KB91C).
• 16 outputs, isolated from the backplane bus
• DC 24V supply voltage
• Output current 0.5A
• Suitable for magnetic valves and DC contactors
• LEDs for supply voltage and error message
• Active channel indication by means of a LED located on converter
module UB4x
1
2
3
4
[1]
[2]
[3]
[4]
Label for module description
Clip
Recessed connector for the
interface to a conversion
module UB4x via the
flattened round cable
Clip
Status indicator on UB4x Pin assignment module
LED
0... .15
L+ L-
Description
LEDs (yellow)
Q+0.0 to Q+0.7 High
Q+1.0 to Q+1.7 Low
when an output is active
the respective LED is
turned on
LED (green)
Supply voltage available
Connector
12
34
2526
Pin
23...26
22
.
.
.
15
14
.
.
.
7
1...6
Assignment
DC 24V supply voltage
Output Q+0.0
.
.
.
Output Q+0.7
Output Q+1.0
.
.
.
Output Q+1.7
Supply ground
Order data
Description
Properties
Construction