Technical data

Manual VIPA System 200V Chapter 2 Assembly and installation guidelines
HB97E - SM - Rev. 09/19 2-9
• Install the connector on the module until it locks with an audible click.
For this purpose you press the two clips together as shown.
The connector is now in a permanent position and can easily be wired.
The following section shows the wiring procedure from above.
• Insert a screwdriver at an angel into the square opening as shown.
• Press and hold the screwdriver in the opposite direction to open the
contact spring.
• Insert the stripped end of the hook-up wire into the round opening. You
can use wires with a diameter of 0.08mm
2
to 2.5mm
2
(1.5mm
2
for
18pole connectors).
• When you remove the screwdriver, the wire is clipped securely.
Wire the power supply connections first
followed by the signal cables (inputs and outputs).
Wiring procedure