Technical data

Manual VIPA System 200V Chapter 2 Assembly and installation guidelines
HB97E - SM - Rev. 09/19 2-7
The following sequence shows the steps required for the removal of
modules in a side view.
• The enclosure of the module has a spring-loaded clip at the bottom by
which the module can be removed from the rail.
• Insert a screwdriver into the slot as shown.
• The clip is unlocked by pressing the screwdriver in an upward direction.
• Withdraw the module with a slight rotation to the top.
Attention!
Power must be turned off before modules are
installed or removed!
Please remember that the backplane bus is
interrupted at the point where the module was
removed!
Removal
procedure
Ç ÇÇÇ