Technical data

Chapter 2 Assembly and installation guidelines Manual VIPA System 200V
2-2 HB97E - SM - Rev. 09/19
Overview
The modules are installed on a carrier rail. A bus connector provides inter-
connections between the modules. This bus connector links the modules
via the backplane bus of the modules and it is placed into the profile rail
that carries the modules.
You may use the following standard 35mm profile rail to mount the System
200V modules:
35 mm
27 mm
15 mm
1,5 mm
35 mm
27 mm
7,5 mm
1 mm
System 200V modules communicate via a backplane bus connector. The
backplane bus connector is isolated and available from VIPA in of 1-, 2-, 4-
or 8tier width.
The following figure shows a 1tier connector and a 4tier connector bus:
The bus connector is isolated and has to be inserted into the profile rail
until it clips in its place and the bus connections protrude from the rail.
General
Profile rail
Bus connector