Specifications

MSD/PT0600/200 - Technical Reference Manual 29
Preset 0 Base Setup is the default preset from
which the MSD200C, PT0200C always will start
from after power-up. Preset = can be user config-
ured only by a special procedure.
The factory set up shown above monitors both the
analogue and digital input. The phase meter and
vector oscilloscope is assigned to bargraph chan-
nels 1, 2 (line #57 and #58).
Column A + B = Status Display Line Number + Destination ID
Column C = Status Display Source ID
Column D + E = Source Line Number + Source ID
Column F = Shows the physical input connection corresponding to the line number
in column D. This combination will always be the same.