User manual

3. Operation Instructions
-The moving head is an LED wash light for onsite decoration
purpose.
-Don’t turn on the fixture if it’s been through severe temperature
difference like after transportation because it might damage the light
due to the environment changes. So make sure to operate the fixture
until it is in normal temperature.
-This light should be keep away from strong shaking during any
transportation or movement.
-Don’t pull up the light by only the head, or it might cause damages
to the mechanical parts.
-Don’t expose the fixture in overheat, moisture or environment with
too much dust when installing it. And don’t lay any power cables
on the floor. Or it might cause electronic shock to the people.
-Make sure the installation place is in good safety condition before
installing the fixture.
-Make sure to put the safety chain and check whether the screws are
screwed properly when installing the fixture.
-Make sure the lens are in good condition. It’s recommended to
replace the units if there are any damages or severe scratch.
-Make sure the fixture is operated by qualified personnel who knows
the fixture before using.
-Keep the original packages if any second shipment is needed.
-Don’t try to change the fixtures without any instruction by the
manufacturer or the appointed repairing agencies.
-It is not in warranty range if there are any malfunctions from not
following the user manual to operate or any illegal operation, like
shock short circuit, electronic shock, lamp broke, etc.
-3-
http://www.djslighting.com/