Owner manual

ManualsBrandsDJI ManualsAir equipmentWooKong-M

Table Of Contents

Flight altitude when fail-safe starts > (reference altitude+20m)，then go-home altitude＝flight altitude when

fail-safe starts

Flight altitude when fail-safe starts <= (reference altitude+20m)，then go-home altitude＝reference altitude +20m

1 Record 2 Flight

3 Hover

5 Go home

4 Ready to go home

6 Land

20m

Home

Go home

Aircraft

Fail-safe/Enable Go-Home Switch

Home Location

(Reference longitude, latitude, altitude )

Signal lost

Stay hover

Signal lost > 3s

Ready to

Go-Home

Hover 15s ,

Then land.

If GPS satellite found >= 6 and last 8s,

at the first time you pull the throttle

stick, then record Home Location

Flight altitude when fail-safe starts

>(reference altitude+20m)

Flight altitude when fail-safe starts

<=(reference altitude+20m)

 Altitude Go-H (Altitude Go-home)

Flight altitude when fail-safe starts > (reference altitude + entered value)，then go-home altitude＝flight altitude

when fail-safe starts.

Flight altitude when fail-safe starts <= (reference altitude + entered value)，then go-home altitude＝

reference altitude + entered value.

Entered value: 20m~300m, the default value is 20m, and has an accuracy of 1m.

2 Flight

3 Hover

5 Go home

4 Ready to go home

6 Land

Input value

1 Record

Home

Go home

Input value

Aircraft

Fail-safe/Enable Go-Home Switch

If GPS satellite found >= 6 and last 8s,

at the first time you pull the throttle

stick, then record Home Location

Home Location

(Reference longitude, latitude, altitude )

Signal lost

Stay hover

Signal lost > 3s

Ready to

Go-Home

Hover 15s ,

Then land.

Flight altitude when fail-safe starts

>(reference altitude+ input value)

Flight altitude when fail-safe starts

<=(reference altitude+ input value)

Go-Home Switch： Before using this function, you have to choose a

2-position switch on your transmitter as the Go-Home switch. Then connect

the correct channel of the receiver to the X3 port of the MC.

You should assign: Position-1 to Start; Position-2 to Standby; or reverse the assignment for Position-1 and Position-2.

Move the Tx switch of the channel X3 and check that the corresponding area Start and Standby turns blue on the

assistant software screen. If required adjust the Tx channel end points.

2-Position