Instructions

INSPIRE 2

User Manual

Stopping the Motors

There are two methods to stop the motors.

Method 1: When Inspire 2 has landed, push the left stick down , then conduct the same CSC that

was used to start the motors, as described above . Motors will stop immediately. Release both

sticks once motors stop.

Method 2: When the aircraft has landed, push and hold the left stick down. The motors will stop

after three seconds.

Method 1 Method 2

2. Abort landing process immediately by using the button on the screen.

3. a. When Landing Protection determines that the ground is suitable for landing, the Inspire 2 will

land gently.

b. If Landing Protection determines that the ground is not suitable for landing, the Inspire 2 will

hover and wait for pilot conrmation.

c. If Landing Protection is not operational, the DJI GO 4 app will display a landing prompt when

the Inspire 2 descends below 0.7 meters. Pull down on the throttle or use the auto landing

slider to land.

4. Aircraft will land and turn off automatically.

Starting/Stopping the Motors

Starting Motors

A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the bottom in-

ner or outer corners to start the motors. Once the motors have started spinning, release both sticks

simultaneously.