Instructions
62
©
2017 DJI All Rights Reserved.
INSPIRE 2
User Manual
3. Hold the aircraft vertically, with nose pointing downward, and rotate it 360 degrees around the
center axis. Recalibrate the compass if the Aircraft Status Indicator glows blinking red.
If the Aircraft Status Indicator blinks red and yellow after the calibration procedure, move
your aircraft to a different location and try again.
DO NOT calibrate the compass near metal objects such as a metal bridge, cars,
scaffolding.
If the aircraft status indicators are blinking red and yellow alternately after placing the aircraft
on the ground, the compass has detected magnetic interference. Change your location.
Auto Take-off and Auto Landing
Auto Takeoff
Use auto takeoff only if the Aircraft Status Indicators are blinking green. Follow the steps below to
use the auto takeoff feature:
1. Launch the DJI GO 4 app, and enter “Camera” page.
2. Complete all steps on the pre-ight checklist.
3. Tap“ ”, and conrm that conditions are safe for ight. Slide the icon to conrm and takeoff.
4. Aircraft takes off and hovers at (1.2 meters) above ground.
Aircraft Status Indicator blinks rapidly when it is using the Vision System for stabilization.
The aircraft will automatically hover below 10 meters. It is recommended to wait until there
is sufcient GPS lock before using the Auto Take-off feature.
Auto-Landing
Use auto-landing only if the Aircraft Status Indicator is blinking green. Follow the steps below to use
the auto-landing feature:
1. Tap on , to ensure the landing condition is ideal. Slide to conrm.