User manual

28
©
2014 DJI. All Rights Reserved.
Remote Control
Connecting the Remote Control to Ronin
1. Insert four AA batteries into the battery compartment on the back of the remote control. Pay
attention to the negative and positive poles.
2. Turn on the Ronin, then turn on the Remote Controllers's power switch. The LED on the Ronin will
blink red at this time.
3. Press and hold the Bind button (shown below) for a few seconds until the LED blinks green
three times. If the LED changes to a solid, red light, the remote control and the Ronin have been
successfully bound. The binding process only needs to be done once unless the bind button is
pressed or if the Ronin needs to be bound to another remote control.
Bind Button
Please make sure the batteries have enough capacity before use. If the low voltage
warning alert sounds, please replace the batteries as soon as possible.
Use the correct type of battery.
For long-term storage, remove the batteries from the remote control.
[1] Antenna
[2] Carrying Handle
[3] 3-Position Switch MODE
[4] 3-Position Switch FUNCTION
[5] Joystick 1(J1;J2)
[6] Joystick 2(J3;J4)
[7] Neck Strap Attachment
[8] Power Switch
[9] Power Indicator
[10] Battery Compartment
[11] Micro-USB Port
Remote Control
[
2
]
[
3
]
[
5
]
[
4
]
[
6
]
[
7
]
[
8
]
[
9
]
[
1
]
J3
J4
J2
J1
[
10
]
[
11
]