User Manual

©
2020 DJI All Rights Reserved.
7
2. Make sure the connections between all the motors and the motion controller are stable.
3. If the motor cannot rotate freely, immediately power it o and check.
Armor
1. Make sure that all the armor is securely mounted, all cables are rmly connected to the motion controller,
and that they are functioning properly.
Gimbal
1. The gimbal includes delicate parts that may be damaged when the gimbal is impacted. Protect the
gimbal from physical damage. Otherwise, the gimbal motor may malfunction.
2. The gimbal and gimbal connector are delicate. Handle with care and DO NOT touch the gimbal
connector. Hold the robot by the chassis when lifting or moving it. DO NOT lift the robot by holding the
gimbal or blaster.
3. DO NOT install or remove the gimbal when it is powered on.
4. Hold the gimbal rmly when installing or removing it.
5. Make sure that the blaster is properly mounted to the gimbal and that the gimbal is free of foreign objects
and can rotate freely when powered o. Otherwise, the gimbal may vibrate and move abnormally during
use.
6. Make sure the speaker is properly installed and does not obstruct the movement of the gimbal.
7. Make sure the cables of the intelligent controller, blaster, speaker, and other modules are correctly
connected and, when applicable, inserted into its corresponding cable slot. DO NOT obstruct the
movement of the gimbal.
8. After powering on the robot, DO NOT cover or touch the gimbal and avoid moving the chassis so that the
self-test can be completed smoothly.
9. DO NOT apply external force to the gimbal when in use.
10. To avoid pinching your ngers, DO NOT touch the rotating part of the gimbal.
11. When the gimbal is in use, DO NOT touch the metal parts on the inner side of the pitch motor as this
area may become hot.
12. Make sure the unused ports on the side of the gimbal are covered. Otherwise, it may become lled with
foreign objects such as water or gel beads, which may lead to corrosion or short-circuiting.
Camera
1. DO NOT expose the camera to liquids or immerse in water.
2. DO NOT store the camera in a humid place.
3. DO NOT touch the lens.