User Manual
4
©
2020 DJI All Rights Reserved.
8. DO NOT use frozen gel beads. Frozen gel beads may block the blaster or could potentially cause
injury or property damage.
9. If the robot will not be used for an extended period, power it o to avoid accidents.
Chassis and Mecanum Wheels
To avoid component malfunction, serious injury, and property damage, observe the following rules:
1. If the Mecanum wheels or chassis are moving at a high speed, they could potentially cause injury or
property damage. Make sure to pay attention when the robot is moving at a high speed.
2. Select a wide space when controlling the robot to move at a high speed. Avoid crashing into any hard
objects or walls at a high speed.
3. DO NOT use excessive force when tightening the screws during assembly and disassembly.
The thread-locking uid on the screws is intended for one- time use. For repeated assembly and
disassembly, thread-locking uid is required.
4. It is recommended to use the robot on flat surfaces such as wooden floors, cement, or carpets.
Uneven surfaces such as sand may damage the Mecanum wheels or motors. DO NOT use the robot
on wet ground or outdoors in rainy or snowy environments.
1. Make sure the motion controller is properly installed before use and the screws on the chassis rear cover
are tightened. Otherwise, the motion controller may become loose, which may aect the movement of
the robot.
Servo
1. When in use, DO NOT touch the servo to avoid injury.
2. DO NOT hit the servo or the connected parts. Otherwise, it may reduce the service life of the servo or
even lead to permanent damage.
3. When the servo overload warning prompts appear in the app multiple times, stop the operation
immediately and check the operation and the structure of the robotic arm or servo.
Robotic Arm
1. DO NOT touch the Robotic Arm while it is in use. Otherwise, users may injure their ngers. DO NOT use
the Robotic Arm to lift or move the robot.
2. DO NOT hit or suddenly pull the Robotic Arm. Otherwise, the Robotic Arm will impact and damage the
servo.
3. Clean foreign objects like droplets and gel bead residue in a timely manner. Otherwise, the surface of the
structure may corrode.