User manual

Table Of Contents

DJI Assistant 2 for Phantom

Update rmware, copy ight records and calibrate the Vision System in the DJI Assistant 2 for Phantom

software. For users that own DJI Agras aircraft, the DJI Assistant 2 for MG can also be used for the functions

above.

Installation and Launching

1. Download the software installation le from the Phantom 4 RTK download page:

http://www.dji.com/phantom-4-rtk/info#downloads

2. Install the software.

3. Launch DJI Assistant 2 for Phantom.

Using DJI Assistant 2 for Phantom

Connecting the Aircraft

Connect the Micro USB port of the aircraft to your computer with a Micro USB cable. Then power on the

aircraft.

Be sure to remove the propellers before using DJI Assistant 2 for Phantom.

Firmware Update

A DJI account is required for rmware updates. Login with your DJI account or register for one.

Data Upload

Save the ight data recorded by the ight controller or the system logs to a local path or upload them.

Flight Data

Click Open Data Viewer to view ight data. Data Viewer is used to view and analyze the ight data les of the

aircraft for performance analysis and troubleshooting.

Calibration

Calibrate the Vision System here when the app prompts for calibration.

Connecting the Remote Controller

Connect the USB-C port of the remote controller to your computer with a USB-C cable. Then power on the

remote controller.

Firmware Update

A DJI account is required for rmware updates. Login with your DJI account or register for one. For the

Phantom 4 RTK Remote Controller, the rmware can only be updated using DJI Assistant 2 if the rmware is

v02.01.0012 or earlier.

DO NOT power o the remote controller during the update.

DO NOT perform the rmware update while the aircraft is in the air. Only carry out the rmware

update when the aircraft is on the ground.

The remote controller may become unlinked from the aircraft after the rmware update. Relink the

remote controller and aircraft if necessary.