User manual

40
©
2020 DJI All Rights Reserved.
Phantom 4 RTK User Manual
Status LED Indicator Description
Charging Mode
—
Solid Yellow
Queuing to charge
......
Blinking Green
Charging
—
Solid Green
Fully charged
—
Solid Red
No battery detected
......
All Blinking Red
Power supply error, please check the connection to the Battery Charger
Storage Mode
—
Solid Yellow
Ready to charge or discharge
......
Blinking Blue
Charging or discharging
—
Solid Blue
The battery’s power level is 50%
—
Solid Red
No battery detected
......
All Blinking Red
Power supply error, please check the connection to the Battery Charger
Status LED Indicator Description
Battery Protection LED Display
The table below shows battery protection mechanisms and corresponding LED patterns.
Battery Level Indicators while Charging
LED1 LED2 LED3 LED4 Blinking Pattern Battery Protection Item
LED2 blinks twice per second Over current detected
LED2 blinks three times per second Short circuit detected
LED3 blinks twice per second Over charge detected
LED3 blinks three times per second Over-voltage charger detected
LED4 blinks twice per second Charging temperature is too low
LED4 blinks three times per second Charging temperature is too high
After these issues are resolved, press the Power Button to turn o the Battery Level Indicator. Unplug the
Intelligent Flight Battery from the charger and plug it back in to resume charging. Note that you do not need
to unplug and plug in the charger in the event of a room temperature error; the charger will resume charging
when the temperature is within the allowable range.
DJI does not take any responsibility for damage caused by third-party chargers.
If the battery level is above 95%, turn on the battery before charging.
How to discharge your Intelligent Flight Battery:
Place the Intelligent Flight Battery into the battery compartment and turn it on. Fly the aircraft out
doors until the battery level is low (such as 20% of power left).