Quick Start

●
● Manual Takeoff and Landing (Stick configurations are for MODE 2)：
● Auto Takeoff and Landing:
●
●
●
●
●
Appendix
To land, gently pull the left stick (throttle stick)
down to lower the aircraft until it touches the
ground. Then pull both sticks to the bottom inside
corners to stop the motors.
Remote Controller is functioning normally,
but is not connected to the aircraft.
Remote Controller is functioning normally
and is connected to the aircraft.
B-B-B... Aircraft Low Battery Level Warning
or Remote Controller error.
B—B—... Remote Controller has been
idle for 5 minutes.
Remote Controller Status LED Camera Controls
●
Adjust the camera parameters using
the Camera Settings Dial on the
Remote Controller or through the DJI
GO app. Press the Shutter Button or
Video Recording Button to capture
photos or record videos.
●
Adjust the gimbal’s tilt using the
Gimbal Dial.
●
Download photos and videos from
the Micro SD card to your mobile
device through the DJI GO app.
You can also use a SD-card reader
to export files to your computer.
●
Never stop the motors mid-flight, otherwise the aircraft will crash. Only stop the motors when on the ground or as required in
emergency situations to reduce the risk of damage or injury.
●
You cannot takeoff if the Intelligent Flight Battery is not sufficiently charged and the Critical Low Battery Warning is active.
●
The Intelligent Flight Battery must warm up if the outside temperature is low. A warning will appear in the DJI GO app in this scenario.
●
Once spinning, the rotating propellers can be dangerous. Do not start the motors when there are people nearby and always fly
in a wide-open area.
●
Power off your Phantom 3 Advanced before switching off the Remote Controller after landing.
Aircraft Status Indicators
Slowly: P-ATTI or ATTI Mode
Quickly: Not connected
to the Remote Controller
Slowly: Low Battery Level Warning
Quickly: Critical Low Battery Level Warning
Solid: Critical error
Blinking Alternately:
Compass calibration required
Slowly: Safe to fly, GPS working
Continuously: Vision Positioning
system working, no GPS
X2
High
Low
Battery Level
High
Low
Battery Level
●
While returning home, you can still control your Phantom 3
Advanced’s altitude to avoid any obstacles.
● Return to Home:
The app’s RTH ButtonRTH Button
1. Press and hold the Return to Home Button on your
Remote Controller until the LED surrounding the button
starts blinking white and starts beeping. Your Phantom
3 Advanced will return to the set Home Point. Press the
button once to stop the procedure.
2. The DJI GO app will warn you if your Phantom 3
Advanced’s battery level falls under a certain level. This
warning threshold can be set in the app. The aircraft
will land immediately if the battery power reaches a
critical level and the Critical Low Battery Level Warning
appears.
3. Failsafe: The Phantom 3 Advanced will enter Return to
Home Mode if the signal to the Remote Controller is lost.
ADVANCED
●
●
●
●
●
©2015 DJI. All Rights Reserved
Designed by DJI. Printed in China.
http://www.dji.com/product/phantom-3-adv
For more information:
Left stick down (Slowly)Left stick up (Slowly)Start / Stop the motors
Start the motors by pulling both control sticks to the bottom
inside (or outside) corners. Release the sticks once the
motors start. Slowly push the left stick (throttle stick) up to
takeoff.
OR
DJI GO
App