User Manual User Manual

Assembly and Use

Camera LED Indicator

Camera LED Indicator lights up after the ight battery is powered on. It provides information on the working status of the

camera.

Camera LED Indicator Wi-Fi status Camera status

Green Solid OFF Power On; Idle

Slow Green Blink (0.2s on, 1.8s off) ON Idle

Green Blink(0.1s on, 0.3s off, 0.1s on, 1.8s off) ON Micro-SD card connected to PC

Fast Green Blink (0.1s on, 0.3s off) ON Synchronizing

Orange Solid OFF Recording

Orange Blink Once (0.2s on, 0.3s off) ON / OFF Taking a single picture.

Orange Blink 3 Times(0.1s on, 0.1s off) ON / OFF Taking 3 or 5 photos per shot

Orange Fast Blink (0.1s on, 0.3s off) ON / OFF Firmware Upgrading

Green, Orange (0.2s green, 1.8s orange) ON Recording

Red Solid ON / OFF Critical error

Slow Red Blink (0.2s on, 1.8s off) ON / OFF CMOS sensor error

Red Blink Once (0.2s on, 0.3s off) ON / OFF Operation failed

Red Blink 3 Times(0.1s on, 0.1s off) ON / OFF Micro-SD card error

Fast Red Blinks (0.1s on, 0.3s off) ON / OFF Upgrade error

Fast Green, Orange and Red Blink

(0.1s on, 0.3s off)

ON / OFF Overheated Camera

4 Attaching the Propellers

Always use original 9-inch propellers, classied by the color of each central nut.

4.1 Introduction

Propellers Grey Nut (9450) Black Nut (9450 R)

Diagram

Assembly Location Attach to motor without black dot. Attach to motor with black dot.

Fastening/

Un-fastening

Instructions

Lock: Tighten propeller in this direction.

Unlock: Loosen propeller in this direction.

4.2 Assembly

(1) (Figure 20) Remove warning cards from motors after you have read them.

(2) (Figure 21) Spin grey marked propellers clockwise onto unmarked motors and black marked propellers anti-

clockwise for black marked motors.

Figure 20 Figure 21

Attaching the Propellers